Troubleshooting
What your assistant's model sees, and fixes for the problems you are most likely to meet.
What your assistant sees
The server works on the projects stored in your Crossprobe account, and reads them there. Your assistant's model sees what the tools return when it asks: for example a part's pins, a net, a list of check results, or a picture of the board. It never gets your files as a whole. Where that model runs is up to your assistant and its settings. See Privacy and data.
Troubleshooting
For the local server, see its own page.
Building a board
- "Nothing was built", with a list of problems. The spec names a symbol, pin or footprint the libraries don't have, or a symbol with pins its footprint has no pads for. The list says which; the assistant corrects the spec and builds again. This does not count as a build.
- The report isn't clean. It lists what is left: unrouted connections, DRC results, parts that found no room. Ask the assistant to make the board larger or use four layers, or to say where a part belongs ("put J2 next to J1").
footprintWarningsare warnings inside a library footprint itself and don't count. - "That position is taken". A part was moved onto another. Ask the assistant to look at the picture and pick a free spot.
- A part is far from where it belongs. Say so: "put the diode next to the fuse", "the connector at the left end of the bottom edge". See what you can say about the layout.
Connecting and saving
"Today's board build is used". An account without a plan gets one build a day; it counts again from 00:00 UTC. What was built can still be looked at and saved. See what it costs.
The assistant can't connect, or gets "401". If it signs in by itself, ask it to connect again (in Claude Code:
/mcp, then the server) and sign in when the browser opens; it may have been disconnected under Connect an assistant… in the account menu. With an access token, the token is wrong, revoked, or was copied without itscp_start: make a new one there."Too many requests without a valid access token" (429). Several attempts from your address had no valid token, and the address is turned away for a few minutes. Fix the token and try again later.
A build was stopped after 150 seconds. The board is too large or too dense for the time allowed. Fewer parts on the sheet, a larger board or four layers make it quicker.
I don't see what the assistant made. Ask it whether it saved: an unsaved proposal doesn't show in the app. Then open the project from the project menu (Open from your account), or with the link the assistant gave you.